Weller XNT H 0.8 mm Chisel 28 mm Soldering Iron Tip for use with WXP65, WTP90, WP65, WXP90

This soldering iron tip is a replacement accessory designed for professional station use, enabling precise thermal transfer for soldering tasks. It fits a range of compatible Weller handles and is shaped to provide a controlled contact surface for joining components. The tip conforms to recognised approval standards and is suited to repair, assembly and prototyping workflows where accurate solder application is required.

• Chisel profile for steady solder flow and good joint wetting
• 0.8mm width for fine but sturdy contact area
• 28mm length for extended reach into tight assemblies
• UPC approval offering documented conformity to standards
• Compatible design for several Weller station types

• Suitable for accurate component soldering on dense boards
• Ideal for rework and repair of small electronic assemblies
• Used with handheld stations requiring replaceable tips
• Can be used for precision soldering in prototyping rigs

It is compatible with a range of Weller stations including specific handheld and bench models that use interchangeable tips.

The flat chisel face increases contact area for efficient heat transfer to leads and pads while allowing controlled solder bridging.

The geometry and size target precise soldering tasks where a narrow contact edge and predictable heat delivery are required.

A longer tip shaft permits access behind connectors and components while keeping the heated area away from surrounding parts.

Weller recommends the use of Weller-branded solder wire (WSW) to achieve the best soldering performance and maximise the service life of your Weller soldering products.