Oxley Yellow Panel Mount Indicator, 1.9V dc, 20mA, Lead Wire Termination, IP66, Flush

This panel-mount indicator provides a compact visual signal for control panels and equipment, delivering a yellow light output for status indication in industrial environments. It is designed for flush mounting in operator interfaces where a low-voltage LED signal is required and connects via flexible lead wires to control circuits.

• IP66 ingress protection ensures operation in wet conditions
• Flush black bezel offers a low-profile appearance
• Lead-wire termination allows simple field wiring
• Operates at 1.9V DC using 20mA for low-power signalling
• Mounts into a 6.4mm hole to suit tight panel layouts
• Compact 13.5mm length minimises intrusion behind panels

• Suitable for motor control and starter panels
• Ideal for status indication on washdown-rated equipment
• Used with low-voltage signalling circuits in control cabinets
• Can be used for machinery safety and fault indication
• Useful on instrument panels requiring slim indicators

It uses lead wires for connection so installers should route and secure flexible conductors to strain-relief points and observe polarity for the LED circuit.

The flush black bezel sits level with the panel surface to reduce snagging and provide a neat, unobtrusive mounting finish.

The IP66 rating protects against powerful water jets and ingress of dust, allowing use in exposed and harsh washdown areas.

Drawing 20mA at 1.9V dc, it imposes minimal load on control supplies and can be powered from typical low-voltage indicator circuits.

These LED indicators should not be operated without a suitable series resistor or other current-limiting device

fixing nut and spring washer