Weller Erem 670EP ESD Safe Tip Cutters

These electronics cutters manufactured from high quality machined tool steel. Cutters have a built-in internal stop and integral return spring to prevent blade overlapping and reduce operator fatigue. All cutters are supplied with soft grip foam rubber grips.

The 670EP cutters from Weller have a straight short relieved head to provide highly precise cuts with a flush finish. The ergonomic handles allow for reduced fatigue in hands when working over long periods. Made from tough and durable tool steel that makes it suitable for cutting SMD and micro packages up to 0.25 mm. Ideal for cutting μ pitches below 0.5 mm, with a maximum cutting capacity of 0.6 mm for copper wire and 0.5 for medium hardness wire

• Protection of electronic components from risks of electrostatic discharge (ESD)

Cutters are hand tools used to cut through wires and are available in a range of shapes and sizes to suit a variety of tasks and applications. The most common type of cutter head is oval, tapered and angled. The type of cut produced depends on the bevel of the cutter. Semi-flush cutters are more durable and produce a quick cut rough rougher edges, whereas an ultra-flush bevel will produce a much cleaner cut but is susceptible to damage. Cutters are commonly used in applications such as:

• DIY

Do not force cutters to cut through material that is too hard for them as it can damage the blades by chipping or blunting them. These hand tools can be cleaned with soap and water, especially the blades, to remove dirt which could cause issues with the joints and encourage corrosion.

This cutter is suitable to cut copper wires 0.1 to 0.6 mm precisely.

The 670EP provides a flush cut, for only mirco pitches under 0.5 mm.