Weller XHT C 3.2 mm Screwdriver 48 mm Soldering Iron Tip for use with WXP200, WP200

This soldering iron tip is a replacement heating accessory designed for use with compatible Weller handheld soldering tools. It provides a flat, screwdriver-shaped contact surface intended for controlled solder transfer and general-purpose joint work in electronic and electrical assembly environments. The tip is sold with UPC approval and integrates with specific Weller tool models to restore or adapt soldering performance.

• Screwdriver-shaped end enables broad solder fillet formation
• Hardened construction reduces wear during repetitive cycles
• Compatible with two handheld tool types for convenient swaps
• 48mm length improves reach into recessed assemblies
• 3.2mm contact width balances heat transfer and access

• Suitable for through-hole soldering requiring broad contact
• Used with WXP200 series tools for routine maintenance
• Ideal for repair work on assemblies with recessed joints
• Used for desoldering and solder redistribution tasks
• Compatible for field servicing using WP200 handpieces

It fits two specific Weller handheld soldering models designed to accept this family of tips, enabling direct replacement without adaptor use.

The flat screwdriver profile provides a larger wetting area and faster heat spread, allowing quicker joint heating and smoother solder flow on wider pads.

The item is supplied with a UPC marking to denote its conformity with the referenced approval standard.

A 3.2mm contact face offers a balance between thermal mass and precision, delivering adequate heat capacity while maintaining controlled joint access.