Weller 60 01 03 2 mm Bevel Soldering Iron Tip for use with WP 60

This soldering iron tip is an interchangeable chisel accessory intended for use with compatible handheld soldering irons. It is designed to deliver controlled heat transfer for general soldering tasks and sits within an established tip family compatible with specific Weller stations. The tip's geometry supports deliberate contact with solder joints in electronic assembly and repair settings.

• Chisel profile provides broad contact for efficient heat transfer
• 45° working angle aids access to angled or tight joints
• 2mm cutting edge enables precise solder application
• Compatible with WP60 shafts for straightforward replacement
• Manufactured to recognised approval standards for component traceability

• Used with WP60 units for routine component soldering
• Suitable for through-hole soldering where flat contact is required
• Ideal for small cable and connector joint work
• Used for repair tasks on densely populated boards
• Suitable for production benches requiring quick tip swaps

The 45° bevel alters the contact plane so the operator can reach pads obscured by adjacent components while maintaining stable heat transfer.

A 2mm wide chisel concentrates thermal energy over a narrow band, enabling controlled solder flow and minimising heat exposure to neighbouring parts.

It is designed for direct replacement on compatible handles, allowing rapid removal and refitting to reduce downtime during maintenance.

The item is produced under an established approval marking, providing traceable adherence to the manufacturer's acceptance criteria.