Weller LT GW2 3.5 mm Gull Wing 18 mm Soldering Iron Tip for use with WSFP/WSP80/WP80/WXP80, LR21/TCPS last generation

This soldering iron tip is a gull-wing-shaped replacement intended for precision soldering tasks. It fits a range of compatible Weller handpieces and stations and is designed for angled access to component leads and surface connections. The tip’s form factor supports focused heat delivery in assembly and repair environments where controlled wetting and reach are required.

• 45° angle improves access for tight lead pitches
• Gull-wing profile facilitates consistent solder fillets
• 18mm length aids reach into recessed areas
• 3.5mm width provides defined thermal contact area
• UPC approval supports recognised quality standards

• Used with WSFP and WSP80 soldering stations
• Suitable for WP80 and WXP80 handpieces
• Can be used for LR21 and TCPS last-generation systems
• Ideal for angled lead soldering on fine-pitch components

It is compatible with specific handpieces and stations that accept LT-series gull-wing geometry and matching shank dimensions.

The gull-wing contour concentrates heat along the pad edge, promoting controlled wetting and uniform fillet formation during soldering.

Use matched power settings and clean the contact face regularly to maintain thermal transfer and consistent joint quality.

The design supports both alloy types by providing stable thermal contact and predictable soldering behaviour within the temperature ranges used for either alloy.