Weller CT2 F7 (370°C) 10 mm Screwdriver Soldering Iron Tip for use with W201

This soldering iron tip is a replacement accessory designed for precision soldering tasks in electronics. It presents a screwdriver-shaped end intended to deliver consistent heat transfer for general-purpose solder joints. The tip is specified to operate at a high temperature of 370°C and is compatible with a particular handheld soldering station model used in workshop and repair environments.

• Screwdriver-shaped end enables broad contact area for joint filling
• 370°C operating temperature supports high-temperature solder alloys
• 10mm working face provides stable heat distribution across pads
• Compatible design allows straightforward fitting to designated iron
• Robust thermal behaviour reduces time-to-wet for quicker joints

• Suitable for filling through-hole solder joints on small PCBs
• Ideal for reworking large pad areas and earth planes
• Used with compatible handheld soldering stations in repair shops
• Can be used for leaded and certain high-temperature alloy soldering

The high operating temperature and broad working face shorten thermal recovery intervals by delivering greater thermal mass to the joint, enabling faster re-heating between solder points.

The screwdriver profile offers an extended wetted surface, which helps control the amount of solder applied and improves bridging resistance on wider pads.

While it provides efficient heat transfer, the larger contact area and 370°C rating mean careful temperature management and appropriate technique are required when working near heat-sensitive parts.

It mounts using the manufacturer's compatible fitting system, ensuring alignment and electrical continuity required for stable temperature performance.