Weller 70 01 10 1 mm Bent Conical Soldering Iron Tip for use with Standard Pyropen, Piezo

This soldering iron tip is designed to perform precision thermal transfer for electronic joining tasks, offering a specialised geometry for angled access and compatibility with handheld gas-powered units. It fits standard Pyropen and Piezo handle types and is intended for use where controlled heat delivery to small targets is required.

• Bent conical geometry provides improved access to confined joints
• 30° angle facilitates angled approach for tight assemblies
• 1mm tip width enables fine solder deposition and control
• UPC-approved finish supports consistent thermal contact
• Compatible with common Pyropen and Piezo ignition systems

• Suitable for delicate electronic component soldering
• Ideal for reach into recessed PCB pads
• Used with handheld gas-powered soldering irons
• Can be used for repair of small connectors and leads

The 30° incline allows the operator to approach joints at an oblique angle, reducing obstruction when working near taller components and improving visual access.

It is engineered to be interchangeable with standard Pyropen and units employing Piezo ignition mechanisms that accept the same tip interface.

The 1mm conical point concentrates heat delivery to a small footprint, supporting accurate solder placement on fine pads and small leads.

Its bent conical form and compatibility with portable gas-fired irons make it appropriate for on-site maintenance where compact, controllable heat is required.