RS PRO Hand Ratcheting Crimp Tool for Coaxial Connectors

473-0648 A high quality low cost ratchet action crimp tool for terminating both 50Ω and 75Ω connector ranges such as BNC, TNC, UHF, mini UHF and SMA, groups A and C.,Not suitable for BNC connectors utilising cable groups H, J, M, S or T.

• Supports RG58 and RG59 wire size
• BNC, TNC connector type
• Suitable for terminating both 50 Ω and 75 Ω connector
• Ergonomic design

Typical Applications

• Maintenance & repair
• Electrical Installations
• Cable assemblies

Note: This tool is not suitable for BNC connectors utilising cable groups H, J, M, S or T.

FAQ:
How easy are they to use?

They are very easy to use with either hand, there is no formal training required for this crimper

How do you maintain the product?

• Movable parts should be regularly lubricated.
• Lubrication* is recommended at least every 10,000 cycles whenever the tool is exposed to contaminants.

The Importance of a High-Quality Crimp

When a crimping tool is used on a terminal, two crimps take place at the same time. One is the electrical connection between the conductor and terminal. The other is the insulation crimp which provides strain relief against vibration and tension. It is important that the electrical connection is gas-tight without any voids between the wire strands and the terminal. If there any voids present, then corrosion can occur causing resistance and excessive heat which damages the electrical connection. Using a good quality crimping tool will ensure that a full, gas-tight crimp is produced preventing future deterioration of the electrical connection and insulation breakage.

Mini Buccaneer