Tele Process Pump Controller, 250 V ac

  • RS Stock No. 182-9996
  • Mfr. Part No. G2ASMA20
  • Manufacturer Tele
Technical data sheets
Legislation and Compliance
RoHS Certificate of Compliance
COO (Country of Origin): AT
Product Details

Pump control, Alternating/parallel

Alternated access of two pumps or other devices
Even distribution of duty
Parallel duty at high demand
Operation using 1 or 2 input signals (two modes of operation)
Timing offset of the two loads to avoid water hammer effcects
Supply voltage selectable via TR2 power modules
2 separate change over relays for device control
Width 22.5mm
Industrial design
Task
Two pumps are installed at a sewage pumping station that are to be run alternately for equal periods to ensure equal wear.
Solution
The pump switchover system activates the pumps alternately, if needed, the second pump can also be activated so that both run at the same time (parallel operation)
Use/value
Equal wear, and therefore longer service intervals for both pumps
Minimised pump failures through nearly equal number of operating hours
Peak load coverage
Zero-voltage safety in the event of power failures
Applications
Centrifugal Pumps
Sewage Pumps
Water & Waste

Specifications
Attribute Value
Supply Voltage 250 V ac
IP Rating IP20, IP40
2 In Global stock for delivery within 4 - 8 working days
Price Each
PHP 8,506.37
(exc. VAT)
PHP 9,527.13
(inc. VAT)
units
Per Unit
1 +
PHP8,506.37
Related Products
A compact and highly efficient motor controller for ...
Description:
A compact and highly efficient motor controller for the RS Pro range of centrifugal micro-pumps. The EQi controller accepts and input voltage of up to 30 volts and pump speed can be controlled from a potentiometer on the board or ...
Features a differential pressure switch, dry running cut-out, ...
Description:
Features a differential pressure switch, dry running cut-out, control panel, pressure reservoir and non-return valveStart up pressure 0.5 to 3.5 bar minimum, adjustableDifferential pressure switch controls water pressure in pumped systems and ensures constant flowHelps to prevent boiler cycling and ...
Fits to pump body or pipe work (pipe ...
Description:
Fits to pump body or pipe work (pipe diameter 20 to 200mm)A rapid rise past the set-point temperature of 45°C (if the inlet water level falls below the centre line of the inlet) of any centrifugal type pump, will cause ...
Genyo control and protection system can be used ...
Description:
Genyo control and protection system can be used on any centrifugal pumps up to 10 m3/hr and 10 bar pressure. Genyo enables automatic control of pump start-up and shutdown based on actual water demand, preventing pressure fluctuations at delivery points. ...